Bosch Washer Dryer Growth from a Leaking Clothes Dryer Vent

Dripping Clothes Dryer Vents are a common trouble that we discover regularly. This is one of the locations that are examined in our Ecological Evaluation procedure. It is very common to find high levels of lint behind the Washer/Dryer place. Sometimes we find mold and mildew growing in this location and other times we do not discover mold and mildew. It is important to examine this occasionally because this can be a high humidity location.

There are numerous reasons that this issue happens. We will certainly note them now:

  • Improper setup on the first day of the Washer/Dryer Installment. Just what takes place is the clamp on the air vent pipeline is not secured properly when the Dryer is pushed back in, the vent pipe slides off. This is an installer error however not all installers are produced just as. This could create a major wetness issue in this area. Otherwise dealt with promptly, the possibility of mold development could happen.
  • House owner pulls bosch was- droogcombinatie bent on clean in this area. In some cases the duct will come off if the Dryer is taken out as well much. This is an one more trouble that we discover in older installations. Sometimes, we find the starting stages of mold and mildew growth on the surface of the dust or drywall behind the Dryer.
  • House owner uses a Vent less Dryer Box. This is a box put on the flooring where the Dryer wears down in the box and gathers the lint. This is an extremely bad selection of ducting your Dryer. We had one in Trick Biscayne, FL where the client had actually been using one for over 3 years. The mold and mildew growth in this area needed Mold and mildew Removal to occur to remove the walls. That is exactly how negative the mold growth remained in this system.
  • Airing vent pipeline creates openings in it from age. This is an additional common problem. You can acquire this flexible plastic exhaust pipe in Home Depot or Lowes. The warmth eventually creates the adaptable pipe to break down and it gets openings in it. Ideal choice is versatile metal duct. You will find this in the exact same place where you located the Plastic Flexible Duct. It costs a little more and requires a bit more work but is worth the expense compared to Form Remediation. Metal Duct is a better selection to stop future mold development in your Washing Location.
  • Last one is rats or tiny pets eat openings in the versatile duct. This is not an usual issue yet it occurs. We had one instance in Stuart, Fl where rats were getting in the house and living in the Garage. The wall behind the Clothes dryer had to have Mold and mildew Remediation and the entire Air duct System needed to be cleansed and sanitized for rodent droppings.

Finally, it is essential that you have this system inspected on a yearly basis making certain you have actually not created any type of leakages. It is additionally important to have this system cleaned every two years as a result of a feasible Fire Hazard. This is also along with the opportunity of Mold Development around. As constantly, if you think any sort of problem in Washer/Dryer Location, call an accredited Expert to check it out.

Leave a Reply